Table of Contents
Write a KERNAL or freezer to EasyFlash 3
EasyFlash 3 can be programmed with any C64 KERNAL.
EasyFlash 3 is compatible with freezer cartridge binaries (firmwares) that can be used in any of the following freezer cartridge hardware:
- Action Replay
- Retro Replay
- Nordic Power / Atomic Power
- Super Snapshot 5
The KERNAL and freezer cartridge slots of EasyFlash 3 are programmed in a similar manner as the EasyFlash slots. See the page Write CRT to EF/EF3 for the general idea.
Write a KERNAL binary
- Start up EasyProg
- Choose M - Menu, K - Write KERNAL to flash
- Select the desired KERNAL slot
- Browse and select the KERNAL binary file*
- Programming begins after the appearing dialog is confirmed
- After a short while EasyProg prompts for KERNAL Name
- When complete, the programmed KERNAL can be selected from EF3 menu after reboot
* The KERNAL file must be exactly 8 192 bytes. It should be in plain binary format without load address.
Write a freezer cartridge binary
- Start up EasyProg
- Choose M - Menu, then select either
- R - Write AR/RR/NP to flash for Replay or Nordic Power image
- 5 - Write SS5 to flash for Super Snapshot 5 image
- Select the freezer slot (AR/RR/NP only)
- Browse and select the freezer binary file*
- Programming begins after the appearing dialog is confirmed
- When complete, the programmed freezer cartridge can be selected from EF3 menu after reboot
* The freezer cartridge image must be in plain binary format (e.g. *.bin, not *.crt).
Das ist eine private Internetseite. Für Schäden, die eventuell durch Informationen auf dieser Seite aufgetreten sind, wird nur im Falle des Vorsatzes oder bei grober Fahrlässigkeit gehaftet. Jegliche Anleitungen, Hardware, Software sind vor dem Nachbau und vor der Benutzung sorgfältig zu überprüfen. Wenn der Leser dazu fachlich nicht qualifiziert ist, darf er die Anleitungen, Hardware bzw. Software von dieser Seite nicht verwenden.
